Used to secure fixtures, wires, threaded rods, and other hardware and It provides a simple and portable means of attaching a hoist to a runway or lifting beam

Board retaining clamp Is used to retaining the scaffolding planks, Thus it is also called scaffolding plank coupler or simply named BRC and Board retaining coupler is conformed to EN 74 and BS1139 standards.

Waller plates are appreciated fortheir exceptional strength, long lasting quality and low maintenance design and Unique tensile strength, simple installation method, vibration resistant attribute, compatibility with different accessories and long lasting quality.

T Bolts / I bolts are used to tighten Swivel and couplers and Fixed Couplers. T Bolts / I bolts are used to replace warn or lost T Bolts/I bolts on scaffolding couplers.Our T Bolts / I bolts are supplied with a washer and nut.

Tie rod water Stopper which is very well threaded compatible with 16mm tie rod and available with cap adopter and Water stopper is with inner screw threads.

Prop Sleeve use to adjust nut up and down and lock tubes at required length and Prop Sleeve made of 60 mm Diameter

Solid adjustable jack nut that is available in different grades, sizes and dimensions as per their requirement of clients. and These jacks are durable in quality and ensure longer servicelife.

We are instrumental in offering an alluring range of superb quality jack nut to our clients. and We provide highly efficient jack nut in standard as well as customized configurations, as per client’s req.

It is made with body cast + steel bolt nut and The gogo nuts we make available features long functional life, corrosion resistance and reliable performance.

Ladder clamp is used to connect a ladder to scaffolding tubes. This clamp allows safe and secure installation of the ladder to the tubes for smooth passage to higher levels

Connects two scaffold tubes at right angles. These are important load bearing components, and the drop forged fittings provide the maximum strength.

Swivel couplers enables two scaffold tubes to be connected together at any angle, they are mainly used for diagonal bracing. and Make EN-74

Anchor Nuts are designed using the best quality cast iorn in different sizes from 90mm to 100mm. It is Used with Tie Rod to Hold Shuttering.

Joins 48 O.D. scaffold tube yp standards end to end internally. Fits inside scaffold tubes. and Expands to fit internal diameter of scaffold tube when bolt tightened.

Joins 48 O.D. scaffold tubes end to end externally.

Anchor Nuts are designed using the best quality cast iorn in different sizes from 90mm to 100mm. It is Used with Tie Rod to Hold Shuttering.

Joint Pin To connect scaffold tubes end to end a joint pin.This tightening causes the two parts of the joint pin to expand gripping the ends of the scaffold tubes.

We provides caster wheel as per clients requirements. With and without Brakes.